Barco HDF W series, Use And Installation Manual

Page: 287 / 319

17. Servicing
17. SERVICING
About this chapter
This chapter contains general servicing procedures like lamp house replacement, input unit replacement etc. These procedures
may only be performed by
quali fi ed technical service personnel .
• Inserting an input module
• Replacement of the dust fi lter on the front side
• Replacement of the dust fi lter on the bottom side
• Replacement of the dust fi lter on the top side
• Pressure veri fi cation of the liquid cooling circuit
• Removal of the lamp house
• Installation of the lamp house
• Realignment of the lamp in its re fl ector
Extra service information
Extra service information for quali fi ed service technicians can be found on Barco’s Partnerzone (URL: http:\\my.barco.com ). Regis-
tration is necessary.
If you are not yet registered, click on Partnerzone registration and follow the instructions. With the created login and password, it is
possible to enter the partnerzone where you can
fi nd extra service information about the projector.
W
ARNING
:
Switch off the projector and unplug the power cord before starting the procedure.
W
ARNING
:
Maximum service time is limited to 2 hours due to possible UV radiation.
17.1 Inserting an input module
W
ARNING
:
Switch off the projector and unplug the power cord before starting the procedure.
How to insert
Loosen both screws of the dummy cover plate (1).
1
2
3
Image 17-1
Insert input module
R5905158 HDF SERIES 16/06/2015 283