Barco HDF W series, Service Manual

Page: 54 / 337

5. Troubleshooting
Code 6057: “Board id: light sensor module not accessible” (Error)
Situation Solution
Only the ID parameters of the Light
Sensor Module are not accessible.
The ID parameters of all other
boards are accessible. Ignore this error message unless other functionality of the light sensor module fails as
well. If so, replace the Light Sensor Module. See XXXX.
The Board ID of all other boards
are also NOT accessible. This
may indicates a malfunction I²C
functionality on the PMP board.
1. Reboot the projector.
2. Replace the PMP board. See "Replacing the PMP board", page 156.
Malfunction Light Sensor Module
(reference 3 image 5-15). Replace the Light Sensor Module. See XXXX.
3
12
Image 5-15
Code 6058: “Board id: light sensor module read error” (Error)
Situation Solution
Light Sensor Module disconnected. Check if the wire unit (reference 12 image 5-15) is connected with the Light Sensor
Module and with the Power Distribution board (reference 6 image 5-13).
Malfunction Light Sensor Module.
The projector can not read from the
installed Light Sensor Module. In case no other “board read errors” appears, replace the Light Sensor Module (CLO).
See XXXX.
Malfunction internal RS485
communication line. The FCB, MCB
and LIM also reports “read errors”. Disconnect the boards one by one from the internal RS485 line until this error
disappears. Replace the board which makes this error goes away. See chapter XXXX,
to know which boards are using the internal RS485 communication line. If the problem
remains replace the PMP.
Code 6059: “Board id: light sensor module write error” (Error)
Situation Solution
Malfunction Light Sensor Module.
The projector can not write to the
installed Light Sensor Module. Replace the Light Sensor Module. See XXXXX.
Code 6060: “Board id: formatter red unknown format” (Warning)
Situation Solution
Old projector software installed.
The ID parameters of the Formatter
board of the RED channel are written
in a format which is not known by the
projector software. Check if the version of the installed projector software is the latest available version. The
latest version can be downloaded from
https://my.barco.com .
Formatter board of the RED channel
has invalid
fi rmware.
Replace the Light Processor. See "HDF Light Processor", page 189.
Corrupt projector software. Reinstall the latest projector software.
50 R5905312 HDF W SERIES 24/01/2013