Barco Galaxy WARP 10 HB, Owner'S Manual

Page: 28 / 155

4. Connections
Master
Slave 1
Daisy Chain to next Slave ...
Two Way
hardwired
remote
Hardwired
remote
Hardwired
remote
10(/100)BASE-T RS 232/422 IN RS 232/422 OUT COMM PORT
Read instructionsbefore
connecting periphals
Sync OK IR
Green operational
Red Stand-by
IR-Reciever Diagnostic Code
CTRL 3 CTRL 2
CTRL 1
Two Way
hardwired
remote
Hardwired
remote
Hardwired
remote
10(/100)BASE-T RS 232/422 IN RS 232/422 OUT COMM PORT
Read instructionsbefore
connecting periphals
Sync OK IR
Green operational
Red Stand-by
IR-Reciever Diagnostic Code
CTRL 3 CTRL 2
CTRL 1
Slave 2
Two Way
hardwired
remote
Hardwired
remote
Hardwired
remote
10(/100)BASE-T RS 232/422 IN RS 232/422 OUT COMM PORT
Read instructionsbefore
connecting periphals
Sync OK IR
Green operational
Red Stand-by
IR-Reciever Diagnostic Code
CTRL 3 CTRL 2
CTRL 1
Null Modem Connector
Image 4-4
RS232 Setup
How to connect a COM800 Setup
Always use the Barco COM 800 Splitter,
R9827941
(240V) or
R9827948
(110V), when using the COM 800 protocol.
1. Use a data cable with at least 9 cores and 2 DB9 female connectors, just cross the pin 2 and pin 3 connection to make a Custom
Null Modem Cable. (image 4-5)
2. Use the Custom Null Modem Cable to connect the COM 800 port of the master-projector to the ’To Switcher’ port on the frontside
of the COM 800 Splitter. (image 4-6)
3. Continue by connecting the slave projectors to the ’To Proj.’ connectors on the backside of the COM 800 Splitter (image 4-6).
4. When dealing with more than 4 slave projectors, the ’To Proj.’ connectors on the backside of the COM 800 Splitter can also be
used to connect extra COM 800 Splitters (image 4-6).
24 R5976698 BARCO GALAXY WARP™ 10 HB 05/04/2004