Barco Galaxy 4 Long Life+ R9040355, Owner'S Manual

Page: 157 / 173

9. Service Mode
3. Press
EXIT
to return to the
Service Mode
menu.
DIAGNOSIS
I2C
FORMATTER
SMPS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9-38
FORMATTER
I2C (34H) OK
CONFIGURATION OK
INITIALISATION OK
SELF TEST OK
RED DISPLAY OK
GREEN DISPLAY OK
BLUE DISPLAY OK
<EXIT> to return
Menu 9-39
9.15.4 SMPS Diagnosis
What can be done?
This info screen will give an overview of the status of the Switch Mode Power Supply (SMPS) board.
How to display the SMPS Diagnosis screen?
1. Push the cursor key ↑ or ↓ to highlight
SMPS
. (menu 9-40)
2. Press
ENTER
to select.
The
SMPS
Diagnosis screen will be displayed. (menu 9-41)
3. Press
EXIT
to return to the
Service Mode
menu.
DIAGNOSIS
I2C
FORMATTER
SMPS
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9-40
SMPS
I2C (30H) OK
AMBIENT TEMPERA OK
NTC OK
TILT SWITCH OK
MICRO SWITCH OK
LAMP TEMPERATUR OK
LPS MAINS OK
SMPS OUTPUT OK
<EXIT> to return
Menu 9-41
9.16 DynaColor™
This menu item is usefully when working with a multichannel setup.
It is advised to use Barco’s xRACU conrol unit to manage the ’linked’ DynaColor™of multiple projectors in a
multi-channel setup.
To connect the projectors follow the same guidelines as described in Constant Light Output.
In a Linked CLO and/or Dynacolor™ setup a maximum of 14 projectors can be linked, all projectors must have
a different projector address between 0 and 13 and all projectors must have the same baudrate.
R5976780 GALAXY SXGA+ SERIES 14/10/2005 153