Barco Galaxy 4 Long Life+ R9040355, Owner'S Manual

Page: 147 / 173

9. Service Mode
9.7 Change Baudrate PC
What can be done?
The baudrate of the projector must be the same as the baudrate of the connected computer. Use this menu to change the baudrate
of the projector.
The following baud rates are available:
•
115200
• 57600
• 38400
• 19200
• 9600
• 4800
• 1200
How to Change Baudrate PC?
1. Push the cursor key ↑ or ↓ to highlight
Change Baudrate PC.
(menu 9-11)
2. Press
ENTER
to select.
The
Change Baudrate PC
menu will be displayed.
The actual baudrate will be highlighted. (menu 9-12)
3. Push the cursor key ↑ or ↓ to highlight the desired Baudrate.
4. Press
ENTER
to accept the selected Baudrate.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
LAMP
MORE ...
Select with
↑
or
↓
then <ENTER>
<EXIT> to return
Menu 9-11
CHANGE BAUDRATE PC
115200
57600
38400
19200
9600
9600
4800
1200
Select with
↑
or
↓
<ENTER> to accept
<EXIT> to return
Menu 9-12
9.8 Lamp Menu
Overview
• Starting Up the Lamp Menu
• Constant Light Output (CLO)
• Linked CLO
• Lamp Mode
• Target CLO Lumens
• Lamp Runtime Warning
9.8.1 Starting Up the Lamp Menu
What can be done?
All information about the lamp is stored inside the lamp house and can be displayed via the projector software, no information can
be changed.
Following Lamp Information can be consulted:
Serial number Unique serial number of the lamp
Article number Article number of the lamp
Run time Total time the lamp is used in this projector
R5976780 GALAXY SXGA+ SERIES 14/10/2005 143