Barco G62-W9, User Manual

Page: 70 / 104

R5914653 /05 G62 70
10.6 Standby Mode
About standby mode
Setup the projector standby mode.
• Standby Mode: Minimum power consumption (0.5 Watt) which does not allow network controlling.
• Network Standby Mode: Low power consumption (< 2 Watt) which allows the LAN module to enter sleep
mode and supports to be woken by Wake on LAN (WoL). When the LAN module is woken by WoL, the
projector is ready to receive commands over the network.
• Communication Mode: More power consumption that allows controlling the projector over the network.
10.7 Power Settings
About power settings
Configure the projector’s power settings. When going on or going to sleep.
Fast Power On
Turn on this function to have the projector automatically turning on when connected to HDMI input sources.
Auto Power Off
Set an interval timer for the projector to automatically turn off if no signal is detected within the specified time
period.
Press the ◄ and ► buttons to increase or reduce time. The available time range is 0-180 minutes.
Sleep Timer
Set an interval timer for the projector to automatically turn off after operating for the specified amount of time.
The available time range is 0-16 hours.
Reset
Reset the power settings to factory default values.
10.8 Light Source Settings
About light source settings
Set up the light source to control the projector brightness.
Light Source Mode
Select a light source mode depending on the installation requirements.
The available options are .
• Normal
• Eco Mode
• Custom Mode
10.9 Shutter
About the shutter
Set up the shutter behavior.
System menu