Barco FL40 - 4K, User Manual

Page: 36 / 126

R5910123 /00 FL40 / FS40 Projectors
36
4.1 Installation process
Recommended Installation sequence
Item Procedure
1 Confirm that the installation area meets all technical and environmental
requirements
2 Decide where the projector will be mounted
3 Unpack the projector and confirm that all equipment is present and in
good working order
4 Mount the projector
5 Install the projector lens
6 Connect the source
7 Power up the projector
8 Set up the image
4.2 Installation conditions
Environmental Conditions
Barco projectors are manufactured according to specific design standards, which also include
environmental conditions. Failing to follow the terms and conditions outlined in this chapter can
result in loss of product warranty
The table below summarize the physical environments in which the projector may be safely operated or
stored.
Environment
Ambient operating
temperature
Relative Humidity Storage condition
0 -1500m +10 to +40 °C 10 – 80% RH – 20 to +60 °C, 10 – 90 %
RH
1500 -3000m +10 to +35 °C 10 – 80% RH – 20 to +60 °C, 10 – 90 %
RH
Maximum Air Flow 900m 3 /hour 10 – 80% RH Not Applicable
Mains power requirement
Projector Power Requirement
FL40 / FS40 projectors 100 – 240V. 60 – 50 Hz.
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that
the instrument panel and cabinet be grounded.
In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a qualified electrician in conformance to local codes. Hardware, wire sizes
and conduit types must comply with local codes.
Ventilation
To ensure that correct airflow is maintained, the projector must only operated when all the covers
are in place. The only exception is the front cover, see
“ Projector safe attachment points ” .
The free space necessary between the air intake and exhaust are shown below.
Physical installation