Barco F90 - W13WUXGA, User Manual

Page: 55 / 103

6. Source menu
Image 6-5
Example of connector settings for an HDMI connector
5. You can change the following:
- To force a limit on the color space, select one of the available color spaces .
- To force a limit on the used signal range, select one of the available signal ranges .
- To set a video timing other than the one native for the connector, select one of the options under EDID .
Note: You cannot change the EDID for SDI connectors.
6.3 Using Dual inputs
Dual Input.
For extended fl exibility to connect high resolution sources with a pixel clock over 330 MHz, the projector is supporting a dual input
mode. In this mode, the left and the right half of the image can be connected to the DVI-1 and DVI-2 respectively, or DP1 and DP2.
To enable this mode, select the source that fi ts in the menu Home/Source
Dual input modes
There are four ways to connect dual input.
• Dual Displayport Columns
• Dual Displayport Sequential
• Dual DVI Columns
• Dual DVI Sequential
For Images to be displayed in this mode, the resolution must be the same on both channels
Signal source setup.
When using dual inputs, it is important that the signal sources are set up correctly, with the correct resolution. Please refer to the
manual for the source itself (PC, Graphic driver card..) in order to obtain a correct setup. If the setup is wrong, no picture will be
visible in dual mode.
The resolution for each dual column channel can be up to 1920x2400 pixels.
The resolution for each dual sequential channel can be up to 3840x2400 pixels. (4K)
Change the EDID for each channel to the correct value. See "Connector Settings", page 49 for EDID setup.
601–426 F70 SERIES 24/10/2017 51