F90-series
Quick Start Guide
1
2
3
Maintenance
Installing lens
1
2
3
2
4
1
4
5
3
Go to www.barco.com and select your product. All available
software and hardware downloads are filed under the Technical
Downloads tab.
Download and unzip the firmware .zip file. Extract and save the
<version>.fw file to a USB stick with FAT-file system. Use the
eject function on your PC to safely remove the device.
Insert the USB stick into the projector’s USB port.
Follow instructions on the LCD display.
CAUTION !
Do NOT turn off, power down, or remove mains power supply
to the projector when an upgrade is in progress.
NOTE !
Once initiated, the upgrade procedure can take up to 20
minutes to complete.
4
Software upgrade
Software upgrade
When handling lens in or out, always close shutter, see keypad explanation. Press Shutter keypad, and verify that the shutter keypad turn in to red
illumination. This indicate that the shutter is off. When lens is installed, open shutter by pressing the shutter key. Shutter open state is verified
when the shutter key illuminates white.
Verify that the lens release lever is in it’s default position, at the far left of the slide, as illustrated
Remove the protective cap at the lens bayonet end
Align the lens so that the red marking on the bayonet end is facing upwards, and towards the red marking on the top of the projector cabinet.
Install the lens bayonet into the lens mount, and then slide it to the right. Check that the lever is firmly at the far right end of the slide before
removing your hand from the lens..
Push the lens release lever in, and slide to the far left position
Pull the lens straight out of the lens mount.
NOTE!! To prevent damage to the lens, and dust contamination in the projector light processor, always replace the lens bayonet cap, lens front cap
and projector lens cap immediately after removing the lens.
Lens Removal
When removing the lens, always close the shutter, see keypad explanation. Press Shutter
keypad, and verify that the shutter keypad turn in to red illumintation. This indicate that
the shutter is off. When lens is installed, open shutter by pressing the shutter key. Shutter
open state is verified when the shutter key illuminates white.
