![background image](http://html1.mh-extra.com/html/barco/f80-q12/f80-q12_user-manual_4243459108.webp)
R5906852 /09
F80
108
enter the black level value with the numeric keys in the remote control.
5.
Move the cursor to
Level
, press enter and adjust this level until the black level equals the level in the blend
zone.
This value can also be entered by the numeric keys on the remote control.
6.
Repeat the same procedure for any other projector connected to this projector, but on the opposite side.
Note:
Do not forget to disable the
Show lines
button after you achieved the desired blend zone.
8.10.5 RGB gain adjustment
About RGB gain adjustment
The purpose of black level correction is to ensure a uniform black level in multi projector setups. Even when
two projectors are of the same type, different projectors will output slightly different colors for black due to
minor variations in their optical components. So if the projected image of the projectors overlap, there will be 3
different black levels: one for the zone where only the picture of the left projector (zone 1), one for the Blend
zone (zone 2), and one for the zone where there is only the picture of the right projector (zone 3).
Picture Left
Picture Right
Blend Zone
Image 8–70
The black levels for zone 1 and zone 3 are typically corrected by defining a black level mask, which is applied
to the image of each projector. This system is already in place but the applied mask is monochrome.
Using the Basic Black Level menu, you can already specify the area of the mask and its contents. But by using
the RGB Adjustment page, you can specify the multiplication factors (gains) for the Red, Green and Blue
colors separately.
How to perform an RGB adjustment
1.
In the main menu, select
Installation
→
Blend and Mask
→
Black Level
.
Image 8–71 Blend and Mask menu, Black level
The Basic black level menu is displayed.
Summary of Contents for F80-Q12
