Barco F400, User Manual

Page: 81 / 220

81 R5915525 /00 Fx400 Series
2. Use the ◄ or ► keys to select the projector orientation mode and press OK to activate.
8.1.2 Projector tilt indication
When to use the tilt sensor menu
The projector has a built-in tilt sensor that detects the angle at which the projector is mounted. If you are in a
situation where you need to fine-tune the projector because you want to achieve a picture at a specific angle
(e. g. perfectly level, or a perfect fit in a multi-projector setup), you can use the tilt sensor menu as an aide
when adjusting the projector feet, rigging frame or other used mounting mechanisms.
About the tilt sensor menu
The Pitch and the Roll is indicated in degrees.
Pitch tilt: A positive value for the Pitch means that the projector is projecting upwards when compared to the
beam axis. A negative value means the projector is projecting downwards.
Roll tilt: Seen from the front of the projector, a positive value means that it rolls to the right. A negative value
means the projector has rolled to the left.
Get an overview
1. In the main menu, select Installation → Position → Tilt sensor .
Image 8–4 Lens menu, Tilt sensor
The Tilt sensor indication menu opens.
Image 8–5 Tilt sensor indication
If you notice the tilt sensor isn’t working correctly (e.g. when compared to a level), you can calibrate
the sensor in the settings menu. For more info, see
“Advanced settings – Tilt sensor calibration”,
page 155 .
GUI – Installation