Barco Event Master E2 Series, User Manual, Page: 58 / 584

R5905948 /12 Event Master Devices 58
Image 4-7: EX rear panel
1 AC connector
2 RJ-45 connector for 10/100/1000 BaseT Ethernet
communications
3 Genlock BNC Input and Output
– –
5 Expansion Links
– –
7 Input cards (HDMI/DP, SDI, DVI)
8 Outputs cards (DVI, SDI)
8 Multiviewer card (HDMI)
The EX image in Image 4-7 is an example only. The EX expansion box does not ship with cards;
cards must be purchased separately.
Description
E2 E2 Jr. S3 – 4K
S3 – 4K
Jr.
EX
1 AC connectors 2 2 2 1 1
2 RJ-45 connector for 10/100 BaseT
Ethernet communications 1 1 1 1 1
3 Genlock Input BNC with passive Loop-
through 2 2 2 2 NA 1
4 S3D In and S3D Out 4 In,
2 Out 4 In,
2 Out 4 In,
2 Out 4 In,
2 Out NA
5 Expansion Link cards 2 NA 2 1 NA 2 NA 3
6 VPU cards 8 4 4 4 2 1 NA
7 Input cards 8 4 3 2 ≤ 2 5
8 Outputs cards 4 3 3 2 ≤ 2 5
9 Multiviewer card 1 1 1 1 NA
Table 4-1: Comparison of Event Master rear-panel connections
1 The EX expansion box internally generates genlock output.
2 E2 Jr. and S3 – 4K Jr. do not have expansion Link cards.
3 The EX has two (2) Expansion Links integrated in the chassis.
4 VPU cards in the E2 and E2 Jr. are internally mounted.
5 Each EX expansion box has two general purpose card slots, each of which may support any E2
input or output card.
AC connectors
Event Master E2, E2 Jr., and S3 – 4K series processors are equipped with two redundant power supplies.
During normal operation the load is shared equally by both supplies. If one supply fails, the second carries the
whole load. Two AC Connector are provided to connect Event Master series processors to your facility
’ s AC
power source through the supplied power cords. A second power supply is optional on the S3 – 4K Jr.
Input Power Specification: 100-240 VAC, 47-63 Hz
On each power supply there are 3 LED lights that provide status information as follows:
• DC Output Power LED: when Green, the supply is outputting valid DC power.
• Status LED: when amber indicates that an error has occurred.
• AC Input Power LED: when green it indicates that the supply is connected to a valid AC power.
Hardware orientation