![background image](http://html1.mh-extra.com/html/barco/e-2320-c/e-2320-c_system-manual_3923134034.webp)
Installing your Barco display controller
34
To perform a quick installation
1.
If you are not going to use your old graphics card, uninstall the
drivers and software for it if you have not already done so.
Note:
If you are using a motherboard containing an on-board
graphics solution and do not intend to use it as part of a
multiple-display setup, disable it either in the computer’s
System Set-up utility (BIOS) or the Windows device manager.
2.
Shut down and disconnect your computer system.
3.
If necessary, remove any previously installed graphics card.
4.
Install the display controller(s) for your B
ARCO
Display System.
5.
Reassemble and connect your computer system.
6.
Install the drivers, QAWeb software and documentation for your
B
ARCO
N
IO
Display System by following the instructions in the
section
“Installing drivers and software”
manual.
Detailed installation
The following instructions will take you step by step through the
installation of the display controller(s) for your B
ARCO
Display System.
1.
If you are not going to use your old graphics card, uninstall the
drivers and software for it if you have not already done so.
2.
Turn off the computer, display(s), and other peripheral devices.
CAUTION –
Wear a
grounded
, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
CAUTION –
Wear a grounded, protective ESD strap when
handling or during installation of the display controller.
Electrostatic charges can damage the display controller.
Summary of Contents for E-2320 C
