DX-100 Rear Panel Connections
DX-100 User’s Guide
For complete details on all installation procedures, please refer to
the
DX-100 User’s Guide
.
100-240V
50-60 Hz, 5.0 A
DIAGNOSTICS
ETHERNET
DMX Thru
DMX In
GENLOCK In
IP Reset
DEFAULT IP
192.168.0.10
SUBNET MASK
255.255.255.0
DVI
In
SD/HD-SDI
In
LED
OUT
Latches
Six Latches are provided to assist
with module removal and insertion.
Important
Do not adjust the latch positions.
They are reserved for authorized
service personnel only.
SD/HD-SDI Input
Connect either one SD-SDI source
or one HD-SDI source. Supported
formats include:
525/60 (NTSC) and 625/50
(PAL) per SMPTE 259M
HD 720p per SMPTE 296M
HD 1080i per SMPTE 292M
DVI Input
Connect either single or dual-link
DVI. EDID protocol is supported.
Accepted input types include RGB or
YCbCr, progressive or interlaced.
All resolutions are supported to the
following maximum pixel rates:
165MHz (single-link)
240MHz (dual-link)
Director Toolset User’s Guide
For complete details on all setup, configuration and operations
procedures, please refer to the
Director Toolset User’s Guide
.
LED Output
One HDMI-type connector is provided for the NNI
LED Output. Connect to Barco FLX LED modules
only. The output can drive one display from any
portion of a selected source. The output is limited to
a maximum resolution of 1024 x 768.
Genlock Input
Connect composite sync
(standard or tri-level) or
black burst.
DMX Control
Currently not implemented.
Ethernet
100BaseT connection for
Director Toolset
communications.
Diagnostic Port
For factory and technical
support use only.
AC Power
Connect to your facility’s
power source.
IP Reset
Two functions are provided:
Ethernet Reset
— Press once to
reset Ethernet parameters to their
default settings
Factory Reset
— Press for five
seconds to reboot and initialize all
parameters to factory default settings.
All saved parameters will be lost.
