Barco DP2K-S Series, User And Installation Manual

Page: 94 / 153

12. Lamp House & Lamp replacement
11 10
2.5Nm
Image 12-25
3. Install the anode wire lug (reference 7 image 12-26) onto the anode socket of the Lamp House as illustrated. Take care of
wire orientation (must fi t through slot of white Te fl on part). Use an open-end wrench of 17 mm to hold the fi rst nut (reference 6
image 12-26) while fastening the second nut (reference 9 image 12-26) with a torque of 9Nm (6.64 lbf*ft) using a torque wrench.
Ensure that there is a fl at washer (reference 8 image 12-26) between the second nut and f the wire lug (reference 7 image 12-26).
Warning: A torque of 9Nm (6.64 lbf*ft) must be applied to fasten the nuts. Make sure that there is no tension on the anode
wire of the xenon lamp.
Note: Alter tightening the two nuts, the connector should still be “ fl oating”.
7
6
8
9
14
9Nm
9Nm
Image 12-26
Tip: Write down the serial number of the xenon lamp. You will need this while updating the lamp parameters after installation
of the xenon lamp. The serial number of the xenon lamp is engraved in the neck of the xenon lamp.
4. Place the protection cap onto the anode socket.
Caution: Ensure the cap is properly installed. It may not come loose from the socket.
Image 12-27
5. Remove the protective packing from the xenon lamp and gently insert the xenon lamp into the Lamp House as illustrated. Lamp
cathode fi rst. Make sure that the anode socket is oriented towards the upper left as illustrated. While inserting the lamp, rotate it
slightly, engaging the pins (reference 11 image 12-28) of the cathode adapter in the foreseen slots. This is to ensure the lamp
cathode is completely inserted. Keep supporting the anode of the lamp with one hand once the xenon lamp is in position.
Caution: Ensure that you wear protective clothing, a full face shield and protective gloves.
Tip: Retain the protective packaging for future use (you will need it when replacing the next lamp).
90 R5977692 DP2K-S SERIES 10/12/2012