Barco DP2K-S Series, User And Installation Manual

Page: 91 / 153

12. Lamp House & Lamp replacement
Image 12-21
8. Remove the protection cap from the anode connector.
Image 12-22
9. Remove the anode wire lug from the anode connector. For this, use a 17mm open end wrench and a 17mm nut driver. Hold one
nut (reference 6 image 12-23) with the open end wrench while releasing the other nut (reference 9 image 12-23) with the nut
driver. Note that there is a plain washer (reference 8 image 12-23) in front of the wire lug (reference 7 image 12-23).
Tip: To avoid losing the plain washer and bolt (reference 8 & 9 image 12-23), place these back immediately after lug removal.
7
6
8
9
Image 12-23
10.Remove the cathode adapter from the xenon lamp by releasing the hexagon socket head cap screw (reference 10 image 12-24)
of the adapter as illustrated. Use a 5mm Allen wrench.
Note: The xenon lamp has a cathode pin with screw thread (reference 11 image 12-24).
11
10
Image 12-24
R5977692 DP2K-S SERIES 10/12/2012 87