11. Convergence
11.3 Converging the blue pattern onto the red pattern
This adjustment procedure assumes that the projector is prepared for convergence adjustment. See "Prepar-
ing for convergence adjustment", page 70.
Necessary tools
No tools.
How to converge the blue pattern onto the red pattern?
1. Slightly turn the blue colored control knob number 1 until the blue pattern in the
center
of the projected image converges with
the red pattern. Note that a turn of a few degrees corresponds with one full pixel. The direction on the control knob corresponds
with the direction of the arrow of the test pattern.
1
Image 11-5
2. Slightly turn the blue colored control knob number 2 until the blue pattern in the
lower left
of the projected image converges with
the red pattern.
2
5
Image 11-6
3. Slightly turn the blue colored control knob number 3 until the blue pattern in the
upper right
of the projected image converges
with the red pattern.
3
6
Image 11-7
4. Repeat step 3 and 4 until
coincidence
is obtained of the blue pattern in the
lower left
and
upper right
of the projected image.
R5977692 DP2K-S SERIES 10/12/2012
71
Summary of Contents for DP2K-S Series
