Barco DP2K-S Series, User And Installation Manual

Page: 52 / 153

8. Communicator Touch Panel
8.1 Introduction
Communicator Touch Panel for digital cinema projectors
The Communicator Touch Panel is designed for multi-user command and control. The Communicator enables users to learn quickly
and operate ef
fi ciently - using an elegant and fl exible Touch Panel interface. The interface’s commonality means that operators
can intuitively use any model in the product line, without restriction, and its user-friendly nature translates directly into a short and
enjoyable learning curve.
Image 8-1
Flexible Touch Panel interface
The Touch Panel interface can be mounted upon a swivel arm which easily fi ts on top of the DP2K-S series projector. One central
locking mechanism of the swivel arm allows instant fi xation of the Touch Panel interface in any position.
The Touch Panel interface can also be installed further away from the DP2K-S series projector. For this purpose an Ethernet cable
up to 50 meter can be used to realize a direct data communication between the DP2K-S series projector and the Communicator
Touch Panel.
The Touch Panel interface can also be connected via a Local Area Network (LAN) in the same way as the DP2K-S series projector.
In this con
fi guration both devices can communicate with each other as well.
The Touch Panel interface requires a voltage 12 VDC and 1,5 ampere. Note that the DP2K-S series projector has a 12 VDC
output which can be used to power up the Touch Panel interface. Nevertheless, the use of a se12 VDC adaptor (1,5 ampere
minimum) is required in case the Touch Panel interface is installed more then a few meters away from the DP2K-S series projector.
Parts location of the Touch Panel interface
A
B
C
D
E
F
G
H
Image 8-2
A
Touch screen
B Communication panel
C Knob to operate central swivel clamp
D Base of swivel arm
E Power input 12 VDC, 1.5A
F RS232 port (sub-D)
G Ethernet port (RJ45)
48 R5977692 DP2K-S SERIES 10/12/2012