![background image](http://html1.mh-extra.com/html/barco/dp2k-12c/dp2k-12c_installation-manual_3917263063.webp)
8. Starting up
8. STARTING UP
About this chapter
This chapter contains the switch ON and switch OFF procedures of the DP2K C-series projector. These procedures enumerate all
the important points which have to be checked prior to switching ON the projector. This is to ensure a safe start up of the projector.
Overview
•
Switching ON the DP2K C-series projector
•
Switching OFF the DP2K C-series projector
8.1
Switching ON the DP2K C-series projector
How to switch ON the DP2K C-series projector?
1. Make sure that the DP2K C-series projector projector is installed upon a stable pedestal. See chapter "Positioning the DP2K
C-series projector at port window", page 13.
2. Make sure that the exhaust system is properly installed. See chapter "Installation of the exhaust system", page 15.
3. Make sure that the right lens is installed for your application. See chapter "Available lenses", page 37.
4. Make sure that the lamp and lamp house are correctly installed. See chapter "Lamp & Lamp House", page 21.
5. Make sure the projector is correctly connected to the power net. See chapter "Connecting the projector with the power net", page
16.
6. Check if a video source is connected with the projector. See chapter "Source input ports of the DP2K C-series projector", page
50.
7. Check if the communicator touch panel is installed. See chapter "Communicator touch panel", page 53.
8. Press the power switch to switch ON the projector. As a result the projector starts up in standby. So, the lamp is OFF and the
dowser closed. No internal pattern is selected. The communicator touch panel starts its initialization procedure.
-
When ’0’ is visible, the projector is switched OFF.
-
When ’1’ is visible, the projector is switched ON.
9. Press the
STANDBY
button on the local keypad or use the Communicator Touch Panel to activate the lamp.
10.Press the
DOWSER
button on the local keypad or use the Communicator Touch Panel to open the dowser. As a result the applied
source will be displayed.
8.2
Switching OFF the DP2K C-series projector
How to switch OFF the DP2K C-series projector?
1. Press the standby button on the local keypad or use the Communicator Touch Panel to switch the projector from operation to
standby. As a result the lamp turns off but the fans remain turning to cool down the projector.
2. Let the projector cool down at least 5 minutes or until the speed of the fans decreases.
3. Switch OFF the projector with the power switch.
R5905050 DP2K C-SERIES 10/07/2012
57
Summary of Contents for DP2K-12C
