Barco Coronis Uniti, User Manual

Page: 28 / 70

K5902079 /11 Coronis Uniti 28
4.1 OSD menu language
About the OSD menu language
By default, the OSD menu comes up in English. However, there’s a wide range of other languages available
for the OSD menu of your Coronis Uniti.
To change the language of the OSD menu:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Menu menu.
3. Enter the Language submenu.
4. Select one of the available languages and confirm.
4.2 OSD menu automatic close function
About the OSD menu automatic close function
By default, the OSD menu will disappear automatically after approximately 90 seconds of inactivity. However,
this function can be disabled so that the OSD menu remains on the screen until manually closed.
To enable/disable the OSD menu automatic close function:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Menu menu.
3. Enter the Automatic Close submenu.
4. Select Enabled/Disabled as desired and confirm.
4.3 Power LED
About the power LED
To prevent distractions, the power LED is off by default when the display is switched on and used in normal
operation. This behavior can be changed so that the power LED will light up during normal operation. Below is
an overview of the different power LED states, in ascending order of power consumption:
• Off: Display not powered, or display operational but power LED function disabled in OSD (see “Power
LED”, page 28 )
• Steady white: Display operational
• Slow blinking amber: Display in suspend mode (requires DPMS mode to be enabled in the OSD menu, see
“DPMS mode”, page 30 )
• Fast blinking amber: Display in standby mode (requires DPMS mode to be enabled in the OSD menu, see
“DPMS mode”, page 30 )
• Steady amber: Display switched off via the standby key, or display in hibernate mode (requires DPMS
mode and Hibernate to be enabled in the OSD menu, see
“DPMS mode”, page 30 and “Hibernate”, page
31 )
To enable/disable the power LED
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Indicator Lights menu.
3. Enter the Power Status submenu.
4. Select Enabled/Disabled as desired and confirm.
Advanced operation