Barco Coronis 3MP LED MDCG-3221, User Manual

Page: 15 / 56

K5902060 /09 Coronis 3MP LED Display
15
Image 2-13
6. Attach the arm stand firmly to the panel using 4 screws M4 x 8 mm.
2.7 First time starting up
Overview
You are now ready to start up your Coronis 3MP LED Display for the first time.
1. Switch on your Coronis 3MP LED Display as described in “ Standby switching ” , page 19.
2. Turn on the computer connected to your display.
If you have properly installed your display and display controller, the Windows start-up messages will appear
once the boot procedure is finished.
Your Coronis 3MP LED Display will be running in a basic video mode at a default refresh rate when
first time starting up. If you are using a Barco display controller, please consult the user guide
delivered with it to install the drivers, software and documentation. When this is done, your display
will automatically detect the connected video input signal(s) and apply the correct video mode and
refresh rate.
Display installation