Barco ClickShare, Installation Manual

Page: 31 / 53

5. Configuring ClickShare
5. CONFIGURING CLICKSHARE
In this section you get an overview of how you can con fi gure the ClickShare product.
• Pairing
• Pre-install of the Client software
• Web Interface
• Software update
5.1 Pairing
Pairing of the Buttons to the Base Unit
To be able to use a Button it should be assigned to the Base Unit you are using. This process is called pairing. By default, the four
Buttons delivered in the ClickShare set are already paired to the speci
fi c Base Unit.
In case you buy additional Buttons or when a Button should be assigned to another Base Unit, the Button needs to be paired (again).
When updating the Base Unit software, it is advised to also pair your Buttons with the Base Unit to update their software.
A Button can only be paired to one Base Unit at a time.
The Button will always make connection to the Base Unit it was last paired to.
To pair a Button to the Base Unit
1. Insert the Button in the USB port at the front of the Base Unit you are using.
Image 5-1
Inserting Button into the Base Unit
Both the LEDs of the Button and the LEDs of the Base Unit are blinking white. This means pairing is in progress.
The Base Unit automatically checks whether the software of the Button is up to date. If not, the Base Unit updates the Button
software. This may take more time.
When the LEDs become static white, the Button is paired to the Base Unit, but no software update was needed. You can unplug
the Button from the Base Unit.
When the LEDs become static red, the Button is paired to the Base Unit and the software update has fi nished. You can unplug
the Button from the Base Unit.
2. Unplug the Button from the Base Unit.
R5900004 CLICKSHARE 21/08/2012 21