![background image](http://html1.mh-extra.com/html/barco/clickshare-cs-100/clickshare-cs-100_installation-manual_473945070.webp)
R5900022 /18
ClickShare CS-100 series
70
Signal strength
1.
Select the Signal Strength. Click on the slider and reduce the broadcasted power (signal strength) until the
desired strength is obtained.
Note:
Too low power and interference by others might lead to connection issues. If so, increase
again the signal strength until the issues are solved.
By default the strength is set to 100%.
Reducing the signal strength limits the effect of overlapping networks in the 2.4 GHz channels. Not
necessary for the 5 GHz channels as their is no overlap.
ClickShare Configurator (WebUI) access via Wi-Fi
1.
To allow access to the configurator via Wi-Fi, check the check box in front of
WebUI available via Wi-Fi
.
Checked: Configurator accessible via Wi-Fi.
Not checked: access to the configurator via Wi-Fi is blocked.
IP address & subnet mask
1.
Log in to the
Configurator
.
2.
Click
Wi-Fi & Network
→
Wi-Fi Settings
.
3.
To change the IP address or subnet mask, click in the input field and enter the 4 octets of the new IP
address or subnet mask.
Note:
This must NOT be 0.0.0.0 for static IP-Address assignment.
6.11 LAN settings
About LAN network settings
A network connection can be configured through DHCP or by manually entering a fixed IP address.
DHCP
Dynamic host configuration protocol. DHCP is a communications protocol that lets network
administrators manage centrally and automate the assignment of IP addresses in an organization's
network. Using the Internet Protocol, each machine that can connect to the Internet needs a unique
IP address. When an organization sets up its computer users with a connection to the Internet, an
IP address must be assigned to each machine. Without DHCP, the IP address must be entered
manually at each computer and, if computers move to another location in another part of the
network, a new IP address must be entered. DHCP lets a network administrator supervise and
distribute IP addresses from a central point and automatically sends a new IP address when a
computer is plugged into a different place in the network.
Hostname & method
1.
Log in to the
Configurator
.
2.
Click
Wi-Fi & Network
→
LAN Settings
.
Summary of Contents for ClickShare CS-100
