1. Safety
Power input AC clip
Image 1-1
Type A
Image 1-2
Type A
Image 1-3
Type C
Image 1-4
Type G
Image 1-5
Type I
1.6
Compliance FCC
Federal Communication Commission Interference Statement
You are cautioned that changes or modi
fi
cations not expressly approved by the part responsible for compliance could void the user’s
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
You may also
fi
nd helpful the following booklet, prepared by the FCC: "How to Identify and Resolve Radio-TV Interference Problems."
This booklet is available from the U.S. Government Printing Of
fi
ce, Washington D.C. 20402.
Changes and Modi
fi
cations not expressly approved by the manufacturer or registrant of this equipment can void your authority to
operate this equipment under Federal Communications Commissions rules.
In order to maintain compliance with FCC regulations shielded cables must be used with this equipment. Operation with non-ap-
proved equipment or unshielded cables is likely to result in interference to radio & television reception.
FCC RF Radiation Exposure Statement: This device is capable of operating in 802.11a mode. For 802.11a devices operating in the
frequency range of 5.15 - 5.25 GHz, they are restricted for indoor operations to reduce any potential harmful interference for Mobile
Satellite Services (MSS) in the US. WIFI Access Points that are capable of allowing your device to operate in 802.11a mode (5 .15
- 5.25 GHz band) are optimized for indoor use only. If your WIFI network is capable of operating in this mode, please restrict your
WIFI use indoors to not violate federal regulations to protect Mobile Satellite Services.
Base Unit FCC ID: 2AAED-R9861510
Button FCC ID (model R9861006D01): XF6-RS9110N1103
Button FCC ID (model R9861500D01): 2AAED-R9861500D01
ClickShare Button R9861500D01 has been tested and meets the FCC RF exposure guidelines.The maximum SAR value reported
is 0.915W/kg.
1.7
EN55022-CISPR22 Class B ITE (Information Technology Equipment)
Warning
This is a class B product. In a domestic environment this product may cause radio interference in which case the user may be
required to take adequate measures.
If this equipment does cause interference to radio or television reception, the user may try to correct the interference by one or more
of the following measures :
•
Re-orientation of the receiving antenna for the radio or television.
•
Relocate the equipment with respect to the receiver.
•
Plug the equipment into a different outlet so that the equipment and receiver are on different branch circuits.
•
Fasten cables connectors to the equipment by mounting screws.
4
R5900031 CLICKSHARE CS-100 01/06/2016
