Barco CineVersum 120, Owner'S Manual

Page: 32 / 43

7. Picture in Picture
7.2 Selecting Input Source for PIP Window
How to select input source for PIP window
The procedure below supposes an already selected input source (main image) and the PIP function set to ’Yes’.
1. Select the input source, remotely accessible with the digit keys on the Remote Control, you desire to be displayed into the PIP
window.
If no valid source is connected to the input of the selected input module, no PiP window appears.
If a valid source is connected to the input, the selected input appears as PiP window on the screen. (image 7-2)
2. If the same input source (PIP image) is selected again, then, the main image is replaced by the PIP image and the PiP window
disappears.
Image 7-2
Picture in Picture
When a PiP window is on the screen, zapping over inputs change only the PiP window. When the same source
is pressed twice, the selected source becomes the main window and the PiP window disappears.
7.3 Function keys for Picture in Picture
Available keys
F1 PiP in left top corner
F1 second time PiP in left top corner, bigger image
F2 PiP in left bottom corner
F2 second time PiP in left bottom corner, bigger image
F3 Swap between main image and PiP
F4 PiP in right bottom corner
F4 second time PiP in right bottom corner, bigger image
F5 PiP is right top corner
F5 second time PiP in right top corner, bigger image
How to use
If second source is selected:
1. press a function key to direct the PiP window to the desired corner. (image 7-3)
2. press a second time on the same function key to enlarge the PiP window. (image 7-4)
3. press F3 to swap between main source and PiP source.
The main source will be displayed in the PiP window and the PiP window source will be displayed on the full screen. (image 7-5)
28 R5976667 CINEVERSUM SYSTEM 01102003