Barco CineVERSUM 110 R9010120, Owner'S Manual

Page: 113 / 135

13. Display Setup
13.8.6 RS232 baudrate
How to change the baudrate?
1. Press MENU to activate the menu bar.
2. Press → to select the
Installation
item. (image 13-27)
3. Press ↓ to pull down the
Installation
menu.
4. Use ↑ or ↓ to select
RS232 baudrate
5. Press → to pull down the menu.
6. Use ↓ or ↑ to select the desired baudrate.
7. Press ENTER to confirm.
Image 13-27
13.8.7 Automatic startup
What can be done ?
The automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing through the
standby state.
The projector restarts at power resume and recovers the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
If the Automatic startup function is enabled one must be aware of the fact that it involves safety precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
How to enable/disable the Automatic startup?
1. Press MENU to activate the menu bar.
2. Press → to select the
Installation
item. (image 13-28)
3. Press ↓ to pull down the
Installation
menu.
4. Use ↑ or ↓ to select
Automatic startup
.
5. Press → to pull down the menu.
6. Use ↓ or ↑ to enable/disable the automatic startup.
On Automatic startup enabled
Off Automatic startup disabled
7. Press ENTER to confirm.
R5976697 CINEVERSUM™ 110 06012004 109