5. Installation Adjustment
Image 5-5
CRT Phosphor Width
How to center the raster?
1. Press the
ENTER
key to activate the raster on the Green CRT faceplate.
2. Look into the Green lens and shift the raster with the cursor keys until it is centered in the middle of the CRT faceplate. (image 5-6)
3. Press the
ENTER
key to activate the raster on the Red CRT faceplate.
4. Shift the Red raster with the cursor keys until the raster is centered on the CRT faceplate.
5. Press the
ENTER
key to activate the raster on the Blue CRT faceplate.
6. Shift the Blue raster with the cursor keys until the raster is centered on the CRT faceplate.
7. Press
ENTER
to continue with the CRT Projection Angle Adjustment.
Image 5-6
Raster Positions
5.9 CRT Projection Angle Adjustment
Introduction
The projection angle of the Red and Blue CRT’s is dependent on the desired size of the projected image. A new projection angle
adjustment is required whenever a new screenwidth SW is adopted. If the centers of green, blue and red do not coincide, the CRT
projection angle must be adjusted.
Following screen will be displayed when starting this CRT Projection Angle Adjustment:
R5976585 BARCO CINE7 26022003
25
Summary of Contents for CINE7 R9010040
