Barco Bragi, Installation Manual

Page: 31 / 192

31 R5911705 /02 Bragi
3.1 Installation process .......................................................................................................................32
3.2 Installation conditions....................................................................................................................33
3.3 Initial inspection............................................................................................................................35
3.4 Positioning the projector................................................................................................................36
3.5 Mounting the projector, general considerations ...............................................................................37
3.6 Mounting surfaces .......................................................................................................................38
3.7 Projector safe attachment points....................................................................................................39
3.8 Removal of the front cover.............................................................................................................41
3.9 Throw distance .............................................................................................................................42
3.10 Scheimpflug (Boresight) adjustment...............................................................................................45
3.11
Scheimpflug adjustment procedure ................................................................................................46
About
This chapter describes the physical conditions and procedures required when installing the projector. It also
describes the outlines and some of the considerations that should be taken in to account when designing and
setting up the installation.
Each projector installation is unique, and as such the information in this chapter is only provided as a
guideline. Likewise, any images or graphical representations shown here are for illustrative purposes only.
If you require further information and assistance during the installation process, contact a qualified projection
technician or your local support office for advice.
CAUTION:
When the projector is installed in a motion platform setup, an additional lens support must be
applied, in order to stabilize the lens, and prevent it from separate from the projector and cause
damage to equipment and personnel.
This lens support must be adapted to the actual installation. There is no standard solution from
Barco available for this purpose.
It is the responsibility of the installer to ensure that the additional lens fixture is approved.
Physical installation
3