CENTER
DETAIL CENTER
SCALE 1 : 5
II
E
B
A
FF
View 2
View 3
FF
DETAIL View 2
SCALE 1 : 4
View 2
K
J
A
DETAIL View 3
SCALE 1 : 4
View 3
K
JJ
STEP 2:
Mount the Center Support
Position the center support (E) on the bottom side
•
of the board (N) with the umbrella hole
Align the holes in the bracket with the intersections
•
of the web on the board
Pre-drill a 1/8" hole 3/4" deep at each hole location
•
Attach the center bracket (E) with two 1-1/4" x 1/4"
•
lag screws (I)
STEP 3:
Attach the Angle Braces
Using two 1" x 5/16" hex bolts (K) and two 5/16" flange
•
nuts (J), attach the angle support (F) to the center
support (E) and end support (A)
Repeat for the opposite side
•
Keep all nuts finger tight until the assembly is complete
•
SQUARE TABLE
INSTRUCTIONS
BM1210
5/7
TOP AND END
SUPPORT
