Barco BarcoReality 908, Installation Manual

Page: 49 / 74

6. Source Connections
6.5 RGB Analog Source with Composite Sync to Port 4/5
Which signal to Port 4/5?
RGB analog input terminals with separate H and V sync inputs, composite sync input or with sync on green (BNC terminals). The
projector detects automatically where the sync signal is located.
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be
connected to the projector as the signal cable coming from the computer is limited to 60 cm due to interfer-
ences.
The RGB analog input accepts only sources with a horizontal frequency of 32 kHz and higher. To connect a
source lower than 32 kHz, an Optional D Limo Pro (R9828631) has to be installed.
Image 6-13
Port 4/5
RGB Analog Video with Composite Sync Input Selection
1. Press digit button 4 or 5 on the RCU.
Button 4 on the RCU Sync. on Green
Button 5 on the RCU Separate Sync.
Table 6-10
Port 4/5
6.6 Component Video Source to Port 4/5
Which signal to Port 4/5?
R-Y)Y(B-Y) analog input terminals with sync input or with sync on the luminance (Y) input (BNC terminals). The projector detects
automatically where the sync signal is located.
Always use an interface (e.g. Barco Magik Interface R9828120) when a computer and local monitor have to be
connected to the projector as the signal cable coming from the computer is limited to 60 cm due to interfer-
ences.
RGB Component Video Port 4/5 Selection
1. Press digit button 6 on the RCU.
6.7 RGB Analog Source with Tri Level Sync to Port 4/5 (Optional)
Which signal to Port 4/5?
RGB analog input terminals with tri level sync input or with tri level sync on green (BNC terminals). The projector detects automati-
cally where the sync signal is located. This feature requires a optional tri level sync module (Order number: R9828040).
R5976354 BARCOREALITY 908 SPLIT PACK 10092002 43