Barco BARCOREALITY 6500, Owner'S Manual

Page: 29 / 127

3. Connections
3.6.1 RS232
Application
1. Remote control :
- easy adjustment of projector via an IBM PC (or compatible) or MAC connection.
- allow storage of multiple projector configurations and set ups.
- wide range of control possibilities.
- address range from 0 to 255.
2. data communications : sending data to the projector or copying the data from the projector to a hard memory device (hard disc,
floppy, etc.).
How to connect ?
1. Connect the serial communication port of computer or Apple MacIntosh to the RS232 in port of the projector. (image 3-8)
Image 3-8
RS232 connection to projector
Set up of the Baud rate for communication.
see Change Baudrate PC, page 81in chapter Service mode.
3.6.2 Communication with peripherals
Configuration of the port.
This port can be configured to accept PPM or RC5 coded signals. To change the port configuration see Defining the Infrared Com-
munication protocol, page 73 in Chapter Installation.
What is possible with an RCVDS05 connected.
• Up to 20 inputs with the RCVDS 05 and 90 inputs when RCVDS’s are linked via the expansion module.
• Serial communication with the projector.
• Remote control buttons on the RCVDS to control the projector (source selection and analog settings).
• The selected source number will be displayed on a 2 digit display and the selected input module will be indicated with a LED
on the rear.
For more information about the use of the RCVDS05, consult the owner’s manual of the RCVDS05.
3.6.3 Mouse
When available ?
Mouse function is only available with the Executive Remote Control (Order number : R9829960 ). The computer can then be con-
trolled via the projector.
R5976182 BARCOREALITY 6500 30012001 25