![background image](http://html1.mh-extra.com/html/barco/balder/balder_installation-manual_473885024.webp)
3. Physical Installation
Mains power requirement
Projector
Power Requirement
Balder
100 –240V. 50 –60 Hz.
To protect operating personnel, the National Electrical Manufacturers Association (NEMA) recommends that the instrument panel
and cabinet be grounded.
In no event shall this projector be operated without an adequate cabinet ground connection.
The AC supply must be installed by a quali
fi
ed electrician in conformance to local codes. Hardware, wire sizes and conduit types
must comply with local codes.
Ventilation
The free space necessary between the air intake and exhaust are shown below.
1000 mm
500 mm
Image 3-1
3.3
Initial inspection
General
Each projector is inspected and rigorously tested at our production facility to ensure that it is free from any mechanical or electrical
defects.
Upon receipt of the projector, we recommend that customers inspect the projector for any signs of damage that may have occurred
in transit. If damage is found,
fi
le a claim with the shipping carrier immediately. Notify the Barco Sales and Service of
fi
ce, or your
preferred Barco agent, of the damage as soon as possible.
Box Contents
Your projector box should contain the following:
•
Projector unit
•
Power cord (suitable for region)
•
Quick start guide
•
Safety manual
•
Remote Control
20
601–0442 BALDER 13/09/2017
Summary of Contents for Balder
