6. Advanced configuration
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 06 – February-2005
_____________________________________________________________________
6-6
6.1.3
Upgrading system software
To upgrade the system software, switch on A
RGUS
and insert the installation CD. A
RGUS
will boot from CD. The
Welcome Screen displays a selection of installation and upgrade options. To upgrade A
RGUS
type
upgrade
and
press the
<Enter>
key.
Figure 6-8
Before the upgrade starts just the keyboard must be specified. Select the type of the used keyboard with the
arrow
keys and confirm
OK
. If you press
Cancel
a keyboard of
us
type becomes installed by default.
Figure 6-9
When the upgrade is finished you are prompted to press the
<Enter>
key to reboot A
RGUS
.
Figure 6-10
The system will reboot now. Remove the CD from the drive as soon as the drawer ejects it. After this system
upgrade you have also to run through
and if you have a distributed system through
Configuring a distributed system
or
3.4.4 Configuring a distributed system with multiple logical screens
.
If you operate A
RGUS
in eXtended safety boot mode, after the upgrade the backup partition
still contains the backup of the working partition containing the state from before the
upgrade. If you are sure that you want to keep the new release it is recommended to make
a new backup of the system, please refer to section
4.8.5 Backup and restore procedures (eosxs
From release 3.4 on the default assignment of video channels in a distributed system has
changed. To maintain the former video assignment the option
-new_video_layout
must
be removed from the X server parameters file
MMTServerConfig
each time after the X.11
configuration before restarting the X server, please see section
.
