1. Charging it up
Before you attempt to charge the card reader, open
the battery cover and remove the plastic strip (if
there is one) covering the battery terminals.
Plug the charging station into a power outlet using
the AC adapter and USB cable provided. Charge the
device for 2-4 hours.
Alternatively, charge the card reader by plugging
the USB cable directly into the side charging port.
Battery status can be checked while the device is off
and charging on the station with a brief press of the
power button.
6
2. Apply RNIB tactile sticker
This will help your blind and partially sighted
customers.
3. Insert till roll
Instructions on the inside of the till roll
compartment will help you make sure it’s inserted
correctly.
Before you begin
Preparing your card reader
Smart tip
If you need to power off for any
reason, press and hold the power
button for three seconds until the
shutdown menu appears on the
screen. Next tap ‘Power off’, followed
by ‘Power off’ again.
A ‘shutting down’ message should
then appear and the device should
turn off.
RNIB tactile sticker
This transparent sticker has a pattern of
raised bumps that enable uses to use the
keypad by touch.
