DAKEXTT250L
5
ASSEMBLY INSTRUCTIONS (continued)
STEP 2: Fit the Legs (B)
Each leg has one open end and the other end has a flat plate. The open end joins to the
table frame.
Take one
TABLE LEG [B]
slide it over a long screw. Align the long screw to come through
the hole in the flat plate at the end of the leg.
Once the long screw is through, push the leg over the mounting in the corner of the table
frame. Ensure the mounting is square and flat against table frame. Then fit in order: one
FLAT WASHER [G]
then one
SPRING WASHER [F]
and fix with one
M10 NUT [E]
onto the
end thread of long screw. Ensure to seat the nut correctly. Tighten the nut by hand
clockwise 2 to 3 full turns. Check the thread is properly engaged by winding the nut up and
down by hand, it should turn quite easily.
With the nut correctly fitted, use the
TOOL [H]
and tighten the nut until it feels firm. Do not
Over Tighten. Once the nut is tightened, fit the
LEG CAP [D]
by aligning all the edges of the
cap all into the edges of the leg tube and with the full palm of your hand, push the leg cap
down into place.
Repeat for the other three legs.