Page 7
Assembly instructions (continued)
STEP 8:
Attach the Tap and Waste Drain Fittings.
STEP 9:
Attach the Sink Assembly. (Use two people for this step)
WHAT YOU NEED:
one x Tap (3)
one x Waste drain fitting set (2)
one x Sink assembly (1)
(i) Remove the pre-assembled
nut (a) and washers (b+c) from
the tap.
(ii) Fit the threaded end of the tap and
the water hoses through the tap
hole and secure with the washers
(b+c) and locking nut (a).
(iii) Fit the waste drain fittings to the
sink bowl in the order pictured,
tighten the flange nut (i) firmly.
(iv) Attach the waste drain flexible
pipe (j).
Note: The flexible pipe (j) must
terminate in a suitable drain point in a
way that complies with your local
regulations based on intended use.
WHAT YOU NEED:
one x Sink assembly (1)
four x M6*16mm screws (A)
Place the sink assembly (1) onto
the cabinet, fix with four M6*16mm
screws (A) as shown.
Plug
d
e
c
b
a
f
g
h
i
j
a – Locking nut
b – Nut
c – Washer
Waste drain fittings:
d – Waste drain body
e – Thin gasket
f – Adaptor gasket
g – Adaptor
h – ‘O’ ring
i – Flange nut
j – Waste drain flexible pipe
A x four