barbas UNIVERSAL-6 65, Installation Instructions & Manual For Annual Maintenance

Page: 9 / 60

9
UNIVERSAL-6 65
Installation instructions
• The appliance may only be set up if the appliance and location meets the
- national and local installation regulations;
- local fi re brigade regulations and required architectural provisions.
• Ensure that the room in which the appliance is situated has adequate ventilation.
• Wood and wood briquettes may be stoked in the appliance.
Do not use any coal and liquid fuels or fuel gel in the appliance. The appliance is not
intended for use of this fuels and can be dangerous and lead to damage to your
health and may seriously damage the appliance.
• Never use the appliance to burn rubbish.
• Please read all instructions / stickers on and around the appliance.
• Read the “Directions for use” before using the appliance for the fi rst time. When you
fi rst fi re up your appliance, there are a number of extra points you should take into
account.
• In transit, some parts of the appliance may have moved from their original place.
Check that the door opens and closes, the brake plates are fi tted correctly to the
brackets at the top of the appliance and the heat-resistant panels are fi xed to the
walls. Check if there are no foreign objects in the appliance.
• Avoid over-loading (white burning glow), caused, for example, by lengthy burning
with primary air (combustion air supply slider all the way to “ + ”) or by burning too
much wood in one go. The appliance can then become over-heated.
• Ask for the local building regulations, before commensing the installation of the
appliance.
•
Install a carbon monoxide alarm. The carbon monoxide alarm should be battery-
powered and designed to operate for the life of the carbon monoxide alarm, following
which it should be replaced. Alternatively a mains powered carbon monoxide alarm
can be used, however this must be fitted with a sensor failure warning device.
•
The carbon monoxide alarm must be fitted and fixed in place within the same room
as the appliance and can be placed either on the ceiling or wall between 1 meter and
3 meter horizontally from the appliance. If fitting to the ceiling it must be at least
300mm from any wall. If fitting to a wall, it must be placed as high as possible above
any doors or windows at 150mm below the ceiling .