3.
Lift the 2 grate plates and remove
from the combustion chamber.
10.5.5
Remove the cast iron rear panels
Only do this procedure after finish of the procedure in section
.
There are 4 cast iron rear panels. Three panels are hooked into each other. The fourth
panel is the fitting piece. The location of this panel is on the left side or the right side.
1.
Identify the fitting piece. The fitting
piece is the most left or the most right
panel on the rear wall.
2.
Move the bottom plate that is in front
of the fitting piece to the center (1).
3.
Lift the fitting piece a small distance
and remove (2).
1
2
Maintenance
Cuatro-7 75-60
45
Summary of Contents for Cuatro-7 75-60
