barbas BOX 20 52, Installation And Maintenance Manual

Page: 14 / 36

4 Safety
4.1 Safety instructions for installation
Warning:
• Installation must be done by a qualified installer.
• Install the appliance in accordance with the following installation
instructions and the national and local applicable regulations.
• Make sure that the area around the fireplace is free of flammable material
at all times. The minimal safe distance is 180 cm.
• Do not install the appliance against a flammable wall. Refer to chapter 4.2
for minimum clearances between the appliance and the wall.
Caution:
• Install the appliance on a floor with adequate load-bearing capacity. Refer
to chapter 8 for the weight of the appliance.
• It is not allowed to connect the appliance to a flue that is also connected to
another appliance.
• Make sure that the chimney has no creaks and is in general good order.
• Install a suitable cap on the chimney outlet to avoid birds' nests build in the
chimney.
• Parts in the appliance can be moved during transportation. Make sure
these parts are in the correct position. See the User Manual.
• Do not use masking tape on the appliance. Masking tape can damage the
finish of the appliance.
• Make sure that the chimney temperature class is at least T400 sootfire
resistant.
• Do not install the appliance in a room with a ventilation system that makes
pressures below -15 Pa.
4.2 Safety distances to flammable and non-flammable materials
Refer to the applicable chapter for minimum safety distances to flammable and non-
flammable materials
Note:
Make sure that flammable materials near the appliance can never reach a
temperature above 85 degrees centigrade.
• BOX 20 52, refer to chapter
4.2.1
.
• BOX 20 52 with wood log storage module, refer to chapter
4.2.2
.
Safety
14 Box 20 52