Attach Goal (I) to Backboard (H).
Remove the Rim box cover, put Goal
against Rim pad (Pre-installed), secure it
with 4 Hex bolts M10x55 (#11), 8 Flat
washers M10 (#12), 4 Flange nuts M10
(#13) See Figure 10.
Tighten all four bolts and nuts.
Put Rim box cover back and secure it with
removed screws.
9.
Figure 9
Figure 10
11 12
I
12 13
Attach Upper Extension arm (G)to
Pole (A),
using one Hex bolt M12x210 (#4), two
Flat washers M12 (#8), two Plastic
washers M12 (#1), and one Lock nut
M12 (#9). See
.
Figure 9
Note: The plastic washer should be placed
between Upper extension arm (G) and Pole
pivot tube (A).
6.
7.
Attach Backboard (H) to Lower Extension arm (F).
Turn crank to lower support frame (F) until against
safety stop.
With 3 capable adults, raise the Backboard assembly
up and connect Lower Extension arm (F) to the
Backboard Bracket using one Stud M12x265 (#2), 2
washers M12 (#8), 2 Plastic washers M12 (#1), and 2
Lock nuts M12 (#9).
Tighten this bolt snugly. See Figure 9.
Note:
1. Slide the Stud thru from outside of Vertical tubes. After
the stud is installed, plug end caps into the holes on the
vertical frame, to keep bees from holes. 4pcs plugs can be
found in the hardware pack or manual pack.
2. The plastic washer goes between backboard bracket (H)
Attach Backboard (H) to Upper
Extension arm (G).
Connect Upper board arm (G) to the
Backboard edge using 2 Hex bolts M12x55
(#6), 4 Flat washers M12 (#8), 2 Plastic
washers M12 (#1), and two Lock nuts M12
(#9).
Tighten the two bolts and nuts snugly.
See Figure 9.
8.
7
6
8
8
9
1
9
8
1
8
6
H
G
G
8
9
4
8
1
8
9
A
8
9
2
1
F
STEP 8
STEP 6
safety stop
STEP 7