1
Forté Power Board Replacement
*** Be sure to have a soft work surface like a towel to prevent the polished casing from being scratched***
*** Read entire document
before
removing motor***
Tools Required:
Standard Phillips screw driver, Offset ratchet Phillips screw driver, Baratza calibration tool or 2mm Allen
wrench
Procedure:
-Case Removal-
1. Clear beans out of the hopper and run the unit briefly to clear any leftover beans from between
the burrs.
2. UNPLUG GRINDER
3. RAISE BOTH LEVER ARMS ALL THE WAY TO THE TOP
4. Remove the 2mm case screw on the top rear of the casing, using our calibration tool
5. Invert the grinder. Using side cutters, remove the rear two feet (ONLY THE REAR FEET)
