12
BARACUDA | TITAN 2 ECO 3
| Installation & Operating Instructions
12
BARACUDA |
TITAN 2 ECO 3
|
Installation & Operating Instructions
• Check that the hydraulic connections are correctly tightened.
• Check that the pump is stable and level.
• The hydraulic circuit must be bled and not contain any foreign bodies.
• The pump pre- filter strainer cover must be correctly closed (by hand}
and its gasket clean and in place.
• Check that the valves are open.
• Start up the pump by activating a speed. The pump always starts in
“priming” mode (2850 rpm for approx. 2 minutes}.
• The pump is self-priming. However, you are strongly recommended to fill
the pre- filter strainer with water before starting it up for the first time to
facilitate the procedure.
• The pump has a priming capacity up to 3 metres above the
swimming pool water level and at sea level elevation (if the hydraulic
circuit is perfectly sealed).
• Bleed any air present in the filtration circuit using the bleed normally
present on the filter (refer to the swimming pool filter’s manual}.
• Check that there are no leaks on the hydraulic circuit.
4. ADDITIONAL USER FUNCTIONS
SPEED
KEYS TO START THE SPEED
PRESET SPEED
ECO SPEED
ECO
1400 rpm
MED SPEED
MED
2150 rpm
HIGH SPEED
HIGH
2850 rpm
PRIMING SPEED
AUTOMATIC AT START-UP
2850 rpm for 2 minutes
• When the pump is running, it displays the operating speed and an LED
lights up above the key which corresponds to the speed.
4.1 Using speeds
If the mains supply is disconnected (manually or via the
filtration lock) the pump will restart at the last active speed.
4.2 Pump shutdown
• press the STOP button