Baracuda is a registered trademark of Zodiac Group Australia Pty Ltd
ABN 87 002 641 965
PO Box 7238, Wetherill Park, NSW 2164 Australia
For more information visit
www.baracuda.com.au
or call Customer Care
1300 784 423
Keep the hose under water and attach the wheel deflector by twist-locking the Quick Connector into the female
hose cuff.
4
While still keeping the hose under water, attach the hose to the cleaner head by pushing the connector onto the pipe
until it clicks in place. Allow the cleaner to drift to the bottom of the pool.
Turn the pool pump on again, and your Zodiac cleaner is ready for cleaning, leaving you with a sparkling pool.
6
To avoid any serious injury and before starting step 6, turn off the pool pump.
a. It is most important to disconnect the head of
the cleaner from the leader hose section when
you remove your Baracuda B3 cleaner out of
the pool.
b. From time to time, ensure the diaphragm is free of debris
and / or dirt and rinse it with water. Simply disconnect the
top of the cleaner to access the Duralife
™
diaphragm.
For care and maintenance
7
Then connect the Pool Pulse™ by pushing the connector onto the pipe until it clicks in place. Turn on the pool pump to
measure the suction flow.
For best performance the Pool Pulse™ needs
to read 2.5
Once this step is achieved, you can disconnect
the Pool Pulse™ from the leader hose.
5
Extremity of the hose
with Wheel Deflecor
and Quick Connector.
Pool
Pulse
®
NOTE:
If Pool Pulse™ reads less then 2.5, then increase AD Flow Valve setting at 3 to increase suction flow.
If the Pool Pulse™ reads more than 2.5, then decrease the AD Flow Valve setting at 1 to decrease suction flow.
