Baracoda BRR-L, Programming Manual

Page: 6 / 33

Nextel RoadRunners Scanner Programming Guide
Last updated: 10/14/05 2 © Baracoda 2005
2 General Configuration
2.1 Reset Default Settings:
Reading the "Default settings” label resets all scanner parameters to the default factory settings and switches it
off.
CAUTION: SCANNING THIS BARCODE WILL RESET THE DEFAULT SETTINGS OF THE SCANNER AND
MAY RESULT IN THE LOSS OF STORED DATA.
Reset defaults settings
\ V T \ V T t \ N U L \ N U L \ F F \ F F
s et def aul t s
2.2 Erase All Barcodes in Memory
The RoadRunners scanner can store barcodes in its internal memory (both in batch mode and in Real Time with
“No Data Loss Mode” ON). Reading the following barcode empties the internal memory of the scanner.
CAUTION: SCANNING THIS BARCODE WILL ERASE ALL BARCODES STORED IN MEMORY AND WILL
RESULT IN THE LOSS OF STORED DATA.
Empty memory
\ V T \ V T \ F N C 4 | \ N U L \ N U L \ F F \ F F
er as e s t or ed bar c odes
2.3 Advanced Features
Use of the “*” on any of the following barcodes indicates the default setting for the manufacturer.
Switch-on Delay
To switch on the scanner in its standard mode, simply press the trigger. It is possible to set up the scanner to be
switched on only after holding the trigger pressed for two seconds by reading the appropriate barcode.