MOUNTING
INSTRUCTIONS
SK1000
SERIES
•
Take assembled Toilet Support and loosen the bolts which hold the
“Hanger” and “S-Bar” together leaving them loosely connected. (See
Figure #2) This is the most important advice that is often overlooked but
will make the assembly much easier!
•
Attach the Support to the Toilet by first removing only two cap nuts and
placing the Hanger with the loosely attached S-Bar over the now exposed
Carrier Bolts, then replace the removed Cap Nuts securing the Hanger to
the Toilet.
WARNING! BREACKAGE OF VITREOUS CHINA
MAY OCCUR IF CAP NUTS ARE OVER TIGHTENED! DO
NOT OVER TIGHTEN CAP NUTS!
If Carrier Bolts are too short
then use the Extended Cap Nuts provided in this package. Again, please
adhere to the above warning about tightening the Cap Nuts.
•
Center the Support as you now tighten the two bolts which connect the
Hanger and the S-Bar together. For proper Bumper positioning (See Profile
Page), tightening these bolts will raise the rubber tightly up against the
bottom of the bowl.
•
Adjust the Non-Skid Foot so that the bottom of the foot pad is 3/8” off the
floor, allowing the entire spring loaded leg to swing freely back towards the
wall then forward to its original position. Once satisfied with the
adjustment, tighten the lock nut above the foot to keep it set in place.
Any Questions or Comments, Contact us at:
WWW.BAR
‐
Industries.com
OR
1
‐
770
‐
877
‐
9020
PATENT(S)
#7089604
