13
Connectors must be inserted home.
When connecting connectors with locks, confirm that their locks are fastened.
Confirm that the wires are not loose.
Confirm that connectors’ plastic sleeves completely cover the connectors
without fail.
Before connecting the connectors, confirm that their sleeves are free from
breakage and their terminals are not oversized.
Connector plugs must be fully inserted.
Confirm that plastic sleeves completely cover the terminals.
Plastic sleeves should not be placed with the open side up.
Wire bunch bands should be fixed at the specified position of motorcycle frame.
Wire clamps must correctly keep wires in place.
Avoid welding stains of welded clamps when clamping wires.
Wire bunches must be fixed away from turning or moving parts.
Do not damage the covering of wire bunches.
In case of wire bunch defects, remedy it with insulating bands.
Wire bunches must not be covered with mounted parts.
Do not twist or bend cables by force. Deformed or damaged cables would
result in poor rotation or damage.
Ⅲ
Ⅲ
Ⅲ
Ⅲ
. SPECIFIED TORQUES
Torques at important positions and standard torques of other positions are as
follows:
SPECIFIED TORQUES
Frame:
Designations of tightening positions
Number
Thread
specification
Torques:
N
·
m
Engine suspension lug mounting nut
1
M10
45
Engine mounting nut
1
M10
45
Front axle nut
1
M12
60
Rear axle nut
1
M16
120
Rear shock absorber upper mounting bolt
1
M10
40
Rear shock absorber lower mounting bolt
1
M8
25
Front shock absorber upper lock bolt
2
M10
40
Steering stem lock nut
1
M25
70
Handlebar mounting nut
1
M10
45
Upper bearing top
1
M25
2.5
Exhaust muffler connector nut
2
M6
12
Exhaust muffler mounting bolt
2
M8
35