90321 Banzai
3
safety area
10 ft (305 cm)
10 ft (305 cm)
Suit up and get drenched on the Slide ‘N Soak Splash Park™ ! Make your way up the
side-climbing wall and race down the water slide before landing with a giant splash in
the refreshing lagoon-style pool. Or cool off under the overhead shower
sprinkler. With the included continuous airflow blower, all of this fun inflates in under 2
minutes. Heavy-duty Dura-Tech™ construction ensures lasting strength and durability.
What are you waiting for? Unfold, inflate, and have fun!
SETUP INSTRUCTIONS
PLACEMENTS: Use on flat lawn only, not pavement or other hard surfaces. Lawn
should be free of rocks, bumps, depressions, sticks, etc. The product should be set up in a
location that has a minimum distance of 10 ft (305 cm) from any free standing structures
or obstructions, including: houses, garages, fences, trees, playground equipment, and
large rocks.
Fig. A2
1. Unfold the constant air inflatable in a desired position on a smooth and level surface.
2. Layout the water hose assembly and match the number on each sprayer to the correct
position on the arch of the inflatable. Once the numbers are matched, attach the sprayers
to the arch and corresponding position using the Velcro patches provided. Secure the water
tubing using the
Velcro hooks &
loops located on top
of the arch, and
down the side of the
inflatable. (Fig
A1-A3)
3. Attach the long
intake tube at the
back of the inflatable
to the mouth of the
blower motor using the attached Velcro Strap. To ensure a secure fit, wrap the strap around
the mouth of the blower and tightly attach the self-sticking strap. (Fig A4-A6)
4. Tie the short air release tube closed with the drawstring provided. (Fig A7)
5. Position the blower in a straight line perpendicular and level to the back of the inflatable.
The blower should be placed on a stable surface and remain upright after the inflatable is
inflated. The blower is a high volume fan capable of moving a lot of air very quickly. Place
the blower in an area where it will not suck in dirt or leaves. Keep blower away from
children, water and moving vehicles. Set up inflatable far away from any structures or
obstructions. Once positioned, secure the blower with the blower ground stakes provided.
(Fig A8)
6. Do not set up over concrete, asphalt, packed earth, or any other hard surfaces. A fall onto a
hard surface can result in serious injury.
7. Locate the loops around the bottom of the inflatable and anchor them to the turf, sand soil
or rock soil with the water slide ground stakes provided. (Fig A9)
8. Ground stakes must be completely inserted into the ground so that no part of the stake is
protruding above the ground surface. This will help prevent tripping or injuries resulting
from a fall.
9. Plug the blower into a properly grounded outlet and turn it on. The inflatable should inflate
in under 2 minutes. Do not allow children to use the inflatable until it is fully inflated.
10. Close the water valve at the bottom of the pool. (Fig A10)
11. Fill the pool with at least 8 in (20 cm) of water before playing. Thoroughly wet all slide
surfaces, platforms and climbing walls before use to ensure optimal play performance.
12. Do not fill the product tub to more than the maximum fill line marked inside the pool wall.
13. After inflation, the blower should run continuously while children are playing.
Fig. A1
Fig. A3
Fig. A4
Fig. A5
Fig. A6
Fig. A7
Fig. A8
Fig. A9
Fig. A10
SETUP
INTRODUCTION
