10
ft
(305cm)
10
ft
(305cm)
safety area
18007 IM_Banzai_12122012
3
1. Unfold the inflatable bouncer in a desired position on a smooth and level
surface.
2. Attach the long intake tube at the back of the bouncer to the mouth of the
blower motor using the attached Velcro Strap. To ensure a secure fit, wrap
the strap around the mouth of the blower and attach the Velcro tightly. (Fig
A1-A3)
3. Tie the short air release tube closed with the drawstring provided. (Fig
A4)
4. Position the blower in a straight line perpendicular and level to the back
of the bouncer. The blower should be placed on a stable surface and
remain upright after the bouncer is inflated. The blower is a high volume
fan capable of moving a lot of air very quickly. Place
the blower in an area where it will not suck in dirt or
leaves. Keep blower away from children, water and
moving vehicles. Set up bouncer far away from any
structures or obstructions. Once positioned, secure the
blower with the orange ground stakes provided.(Fig
A5)
5. Do not set up over concrete, asphalt, packed earth, or
any other hard surfaces. A fall onto a hard surface can
result in serious injury.
6. Locate the loops around the bottom of the bouncer and
anchor them to the ground with the large yellow ground
stakes provided. (Fig A6)
7. Ground stakes must be completely inserted into the
ground so that no part of the stake is protruding above
the ground surface. This will help prevent tripping or
injuries resulting from a fall.
8. Plug the blower into a properly grounded outlet and
turn it on. The bouncer should inflate in less than 1 minute. Do not allow
children to use the bouncer until it is fully inflated.
9. After inflation, the blower should run continuously while children are
playing.
Fig. A3
Fig. A1
Fig. A2
Fig. A6
Fig. A5
Fig. A4
Placement:
Use on flat lawn only, not pavement or other hard surfaces. Lawn should
be free of rocks, bumps, depressions, sticks, etc. Mega Bouncer™
should be set up in a location that has a minimum distance of 10 ft
(305cm) from any free standing structures or obstructions, including:
houses, garages, fences, trees, playground equipment and large rocks.
Bounce and climb this giant 7 ft (213cm) square jumper that
gives plenty of room for bouncing fun! The blower motor
provides constant air support for endless bouncing action
and makes the jumper resistant to small tears and punctures.
Quick set-up and puncture-resistant Dura-Tech™
construction makes this an ideal portable jumper. The Velcro
closures keep the bouncing fun contained, while the
see-through mesh allows children to stay in constant view.
Setup Instructions
Introduction
Set up
