90354 Banzai
3
safety area
10 ft (305 cm)
10 ft (305 cm)
Fig. A2
Fig. A1
Fig. A3
Fig. A4
Fig. A5
Fig. A6
Fig. A7
Fig. A8
Fig. A9
Fig. A10
Fig. A11
OR
OR
Fig. A12
SETUP
INTRODUCTION
SETUP INSTRUCTIONS
Bring the water park experience to your backyard with the Lazy River Adventure Park™!
Make your way up the climbing wall and seat yourself onto an inflatable river ring. The
slide dips you into an open splash pool as you coast under the refreshing waterfall arch.
There’s even a water-blasting cannon and overhead shower sprinkler to keep you even
cooler on those lazy days of summer!
PLACEMENTS: Use on flat lawn only, not pavement or other hard surfaces. Lawn should be
free of rocks, bumps, depressions, sticks, etc. The product should be set up in a location that
has a minimum distance of 10 ft (305 cm) from any freestanding structures or obstructions,
including houses, garages, fences, trees, playground equipment and large rocks.
1. 1. Unfold the constant air inflatable and place in the desired position on a smooth and level surface.
2. Layout the water hose assembly and match the number on each sprayer to the correct position on the arch of the
inflatable. Once the numbers are matched, attach the sprayers to the arch and corresponding position using the
Velcro straps provided. Secure the water tubing using the Velcro hooks & loops located on top of the arch, and
down the side of the inflatable. (Fig A1-A3)
3. Attach the long intake tube at the back of the inflatable to the mouth of the blower motor using the attached Velcro
Strap. To ensure a secure fit, wrap the strap around the mouth of the blower and tightly attach the self-sticking
strap. (Fig A4-A6)
4. Tie the short air release tube closed
with the drawstring provided.(Fig A7)
5. Position the blower in a straight line
perpendicular and level to the back of
the inflatable. The blower should be
placed on a stable surface and remain
upright after the inflatable is inflated.
The blower is a high volume fan
capable of moving a lot of air very
quickly. Place the blower in an area
where it will not suck in dirt or leaves.
Keep blower away from children, water and moving vehicles. Set up the inflatable far away from any structures or
obstructions. Once positioned, secure the blower with the blower ground stakes provided.(Fig A8)
6. Do not set up over concrete, asphalt, packed earth, or any other hard surfaces. A fall onto a hard surface can
result in serious injury.
7. Locate the loops around the bottom of the inflatable and anchor them to the turf, sand soil or rock soil with the
water slide ground stakes provided. (Fig A9)
8. Ground stakes must be completely inserted into the ground so that no part of the stake is protruding above the
ground surface. This will help prevent tripping or injuries resulting from a fall.
9. Plug the blower into a properly grounded outlet and turn it on. The inflatable should inflate in under 2 minutes. Do
not allow children to use the inflatable until it is fully inflated.
10. Close the water valve at the bottom of the pool. (Fig A10)
11. Fill the pool with at least 8 in (20 cm) of water before playing. Thoroughly wet all slide surfaces, platforms and
climbing walls before use to ensure optimal play performance.
12. Do not fill the product tub to more than the maximum fill line marked inside the pool wall.
13. After inflation, the blower should run continuously while children are playing.
FOR INFLATABLE RIVER RING:
14. Roll out the river ring. Inspect for holes, tears or other damage. (Fig A11)
15. Inflate this product with AIR. (Fig A12)
NOTE: For easy air inflation, use a manual air pump designed specifically for plastic inflatables.
BY MOUTH: Remove the air valve plug and squeeze the base of the valve causing the inner flap to open for
inflation.
BY PUMP: Remove the air valve plug and insert air pump nozzle into the valve. The air pump nozzle should be
inserted deep enough to open the inner valve flap.
Do not over inflate the item. Once the item is completely inflated, then insert the air valve plug to seal it shut.
NOTE: Fill inflatable with air until it is firm and solid. If there is any straining at the seams, the item is over inflated.
If any seam begins to strain, immediately stop inflation and release air to reduce the
pressure until all signs of stress on the inflatable are gone. DO NOT use the inflatable if
there is straining at the seams. Use of an over-inflated item may result in serious injury,
paralysis or death.
Inspect this product for rips, tears or punctures. Do not use if damaged.
