WARNING:
Overfilling will cause damage to
your ball.
This product is intended to be used
as a toy and not as a personal
flotation device.
Inflate this product with AIR.
NOTE: For easy air inflation,
use a manual air pump
designed specifically for
plastic inflatables.
10 ft (305 cm)
10 ft (305 cm)
safety area
Fig. A2
Fig. A1
Fig. A3
Fig. A4
Fig. A5
Fig. A6
Fig. A8
Fig. A9
Fig. A10
Fig. A11
OR
OR
Fig. A12
Fig. A13
1. Unfold either one constant air inflatable and place in the desired position on a smooth and level surface.
2. For water slide lay out the water hose assembly and match the number on each sprayer to the correct position on
the arch of the inflatable. Once the numbers are matched, attach the sprayers to the arch and corresponding
position using the Velcro straps provided. Secure the water tubing using the Velcro hooks & loops located on top
of the arch, and along the side of the inflatable. (Fig A1-A3) (For slide only)
3. Attach the long intake tube at the back of the inflatable to the mouth of the blower motor using the attached Velcro
strap. To ensure a secure fit, wrap the strap around the mouth of the blower and tightly attach the self-sticking
strap. (Fig A4-A6)
4. Use the drawstrings to tie shut the short air release tube
along the back of the constant air inflatable. (Fig A7)
5. Position the blower in a straight line perpendicular and
level to the back of the inflatable. The blower should be
placed on a stable surface and remain upright after the
inflatable is inflated. The blower is a high-volume fan
capable of moving a lot of air very quickly. Place the
blower in an area where it will not suck in dirt or leaves.
Keep blower away from children, water and moving vehicles. Set up the inflatable far away from any structures or
obstructions. Once positioned, secure the blower with the blower ground stakes provided.(Fig A8)
6. Do not set up over concrete, asphalt, packed earth, or any other hard surfaces. A fall onto a hard surface can
result in serious injury.
7. Locate the loops around the bottom of the inflatable and anchor them to the turf, sand soil or rock soil with the
water slide ground stakes provided. (Fig A9)
8. Ground stakes must be completely inserted into the ground so that no part of the stake is protruding above the
ground surface. This will help prevent tripping or injuries resulting from a fall.
9. Plug the blower into a properly grounded outlet and turn it on. The inflatable should inflate in under 3 minutes. Do
not allow children to use the inflatable until it is fully inflated.
10. After inflation, the blower should run continuously while children are playing.
WATER SLIDE:
11. Close the water valve at the bottom of the pool. (Fig A10)
12. Fill the pool with at least 8 in (20 cm) of water before playing. Thoroughly wet all slide surfaces, platforms and
climbing walls before use to ensure optimal play performance.
13. Do not fill the product tub to more than the maximum fill line marked inside the pool wall.
FOR INFLATABLE BASKETBALL / WATER POLO / VOLLEYBALL:
14. Roll out the ball. Inspect for holes, tears or other damage. (Fig A11)
15. Inflate this product with AIR. (Fig A12)
NOTE: For easy air inflation, use a manual air pump designed specifically for plastic inflatables.
BY MOUTH: Remove the air valve plug and squeeze the base of the valve causing the inner flap to open for
inflation.
BY PUMP: Remove the air valve plug and insert air pump nozzle into the valve. The air pump nozzle should be
inserted deep enough to open the inner valve flap.
Do not over inflate the item. Once the item is completely inflated, then insert the air valve plug to seal it shut.
NOTE: Fill inflatable with air until it is firm and solid. If there is any straining at the seams, the item is over inflated.
If any seam begins to strain, immediately stop inflation and release air to reduce the pressure until all signs of
stress on the inflatable are gone. DO NOT use the inflatable if there is straining at the seams. Use of an
over-inflated item may result in serious injury, paralysis or death.
Inspect this product for rips, tears or punctures. Do not use if damaged.
16. Lay out the volleyball net and attach it to the pillar of the inflatable using Velcro patches provided. (Fig A13)
SETUP
99523 Banzai
3
10 ft (305 cm)
10 ft (305 cm)
Climb ‘N Bounce Clubhouse
INTRODUCTION
There are so many ways to play with the 2-in-1 Ultimate Combo Pack! When the weather
heats up, cool off with the Aqua Sports Water Park. Will you race down the slide or
challenge a friend to volleyball, soccer, basketball or water polo? There’s even a
refreshing overhead sprinkler! As the weather cools, bounce into fun with the Climb ‘N
Bounce Clubhouse. There’s more bounce to the ounce with its 2 slides, 2 basketball
hoops, climbing wall and a roomy bounce area. Invite the entire neighborhood—the
included continuous-airflow blower motor, each item inflates in under 3 minutes. Wet or
dry, your backyard will be the ready for fun all year long!
SETUP INSTRUCTIONS
Aqua Sports Water Park
safety area
PLACEMENTS: Use on flat lawn only,
not pavement or other hard surfaces.
Lawn should be free of rocks, bumps,
depressions, sticks, etc. The product
should be set up in a location that has
a minimum distance of 10 ft (305 cm)
from any freestanding structures or
obstructions, including houses,
garages, fences, trees, playground
equipment and large rocks.
Fig. A7
